298 Using the Control Panel
SemiThk
Adjusts the density for high quality paper. Printing becomes
darker as the value increases.
Thick
Adjusts the density for thick paper. Printing becomes darker as
the value increases.
ExtraThk
Adjusts the density for special thick paper. Printing becomes
darker as the value increases.
Card
Adjusts the density for postcards. Printing becomes darker as the
value increases.
Envelope
Adjusts the density for envelopes. Printing becomes darker as the
value increases.
Feed Offset
Adjusts the vertical position in which to start printing. The
position moves lower on the sheet as the value increases. This
setting is used when doing single-sided printing or printing the
first page for duplex printing.
Scan Offset
Adjusts the horizontal position in which to start printing. The
position moves to the right of the sheet as the value increases. This
setting is used when doing single-sided printing or printing the
first page for duplex printing.
Calibration
Executes the process control after finishing the print job.
To Next Page
Loading...
Need help?
General
