Paper Handling 53
3
3
3
3
3
3
3
3
3
3
3
3
Labels
You can load up to 75 sheets of labels into the MP tray at one time.
However, you may need to feed some labels one sheet at a time,
or load them manually.
Note:
❏ Duplex printing is not available for labels.
❏ Depending on the quality of labels, the printing environment, or the
printing procedure, labels might be wrinkled. Make a trial print run
before you print on a lot of labels.
When loading labels, you should make paper settings as shown
below:
❏ Make settings on the Basic Settings menu in the printer driver.
❏ You can also make these settings on the Setup menu’s Tray
Menu on the control panel. See “Tray Menu” on page 293.
Note:
❏ You should only use labels designed for laser printers or plain-paper
copiers.
❏ To prevent the label adhesive from coming into contact with product
parts, always use labels that completely cover the backing sheet, with
no gaps between the individual labels.
❏ Press a sheet of paper on top of each sheet of labels. If the paper sticks,
do not use those labels in your product.
Paper Size: A4 or LT
Paper Source: MP Tray (up to 75 sheets)
Paper Type: Labels
To Next Page
Loading...
Need help?
General
