Epson AcuLaser CX11 - Scanned Image Problems; The Edges of a Document Are Not Scanned; The Scanned Area Is Inappropriate

Scanning Problems 413
14
14
14
14
14
14
14
14
14
14
14
14
Scanned Image Problems
The edges of a document are not scanned.
Place the document away from the edges of the document table
to avoid any unwanted image cropping.
The area with a width of 1.5 mm from both horizontal and vertical
rulers cannot be scanned.
1. Maximum unreadable area of 1.5 mm
2. Maximum unreadable area of 1.5 mm
Note:
These values are used for reflective documents. We recommend that
you use the film holder for films.
The scanned area is inappropriate.
Make sure if the transportation lock on the left side of the
document table is set in the unlocked position. The
transportation lock must always be set in the unlocked
position except when transporting the product. See “Scan
Settings” on page 303.
2
1