Using the Control Panel 317
9
9
9
9
9
9
9
9
9
9
9
9
Reset
The product’s current interface has been reset and the buffer has
been cleared. However, other interfaces are still active and retain
their settings and data.
Reset All
All Printer Settings have been reset to the default configuration,
or to the last settings that were saved.
Reset to Save
A control panel menu setting was changed while the printer was
printing. Press the x B&W Start or x Color Start button to clear
this message. The setting is enabled after printing has finished.
Alternatively you can clear this message by performing Reset or
Reset All on the control panel. However, the print data will be
deleted.
ROM CHECK
The printer is checking the ROM.
Service Req Cffff/Service Req Eggg
A controller error or a print engine error has been detected. Turn
off the printer. Wait at least 5 seconds, then turn it back on. If the
error message still appears, write down the error number listed
in the LCD panel (Cffff/Eggg), turn off the product, unplug the
power cord, then contact a qualified service representative.
Sleep
The printer is currently in power-save mode. This mode is
canceled when the product receives job data or the Reset
button is pressed.
To Next Page
Loading...
Need help?
General
