Epson EB-810E - Page 145

•
For inf
rastructure mode, set the Simple AP setting to O and go to
next step.
•
If you installed the optional wireless LAN module and want to use both
connection methods at the same time, set the Simple AP setting to On
and go to next step.
h
Select the Wireless LAN menu and press [Enter].
e projector starts searching for access points.
You can also search for access points using the Sear
ch Access Point
setting manually. See the Specications for details on the supported
channels.
i
Select the access point you want to connect to.
If you need to assign the SSID manually, select SSID t
o enter the
SSID.
j
Assign the IP settings for your network as necessary.
•
If yo
ur network assigns addresses automatically, select IP Settings to set
the DHCP setting to On.
•
If you must set addresses manually, select IP Settings to set the DHCP
setting to O, and then enter the projector's IP Address, Subnet Mask,
and Gateway Address as necessary.
k
To prevent the IP address from being displayed on the network
infor
mation screen, set the IP Address Display setting to O.
Wireless Network Projection
145