Epson EB-810E - Page 245

Indicator and status Problem and solutions
Power: Flashing blue
Stat
us: Indicator status
varies
Laser: Indicator status
varies
Temp: Flashing orange
Projector is too hot.
•
Make sure that the vents and air lter are not clogged
with dust or obstructed by nearby objects.
•
Clean or replace the air lter.
•
Make sure the environmental temperature is not too
hot.
Power: O
Stat
us: Flashing blue
Laser: O
Temp: Lit orange
Projector has overheated and turned o. Leave it turned
o to cool down for 5 minutes.
•
Make sure that the vents and air lter are not clogged
with dust or obstructed by nearby objects.
•
Make sure the environmental temperature is not too
hot.
•
Clean or replace the air lter.
•
If operating the projector at high altitude, set the
High Altitude Mode setting to On in the projector's
Installation menu.
•
If the problem persists, unplug the projector and
contact Epson for help.
Power: Flashing blue
Stat
us: Indicator status
varies
Laser: Flashing orange
Temp: Indicator status
varies
Laser warning
Turn the projector o, unplug it, and contact Epson for
help.
Indicator and status Problem and solutions
Power: Flashing blue
Stat
us: Indicator status
varies
Laser: Flashing orange
Temp: Flashing orange
Obstacle detection warning.
A beep sounds, and the message Playback has been
stopped for safety reasons. Move away from the lens
or remove any obstacles around the lens. is displayed.
e brightness of the light source is reduced.
•
Make sure that there are no obstacles interfering with
the projection window. Remove any obstacles.
•
Clean the obstacle sensor if there are no obstacles.
e projector turns o automatically if no action is taken.
Power: O
Stat
us: Flashing blue
Laser: Lit orange
Temp: O
Laser has a problem.
Turn the projector o, unplug it, and contact Epson for
help.
Power: O
Stat
us: Flashing blue
Laser: O
Temp: Flashing orange
A fan or sensor has a problem.
Turn the projector o, unplug it, and contact Epson for
help.
Power: O
Stat
us: Flashing blue
Laser: Flashing orange
Temp: O
Internal projector error
Turn the projector o, unplug it, and contact Epson for
help.
Power: O
Stat
us: Flashing blue
Laser: Lit orange
Temp: Lit orange
Obstacle detection error.
If there are no obstacles interfering with the projection
window, turn the projector o, unplug it, and contact
Epson for help.
Projector Indicator Status
245