FLIR D3200 Series - Using the PTZ Menu (Local DVR)

148
Appendix B: Connecting a PTZ Camera
3 Configure the following according to your PTZ
camera’s specifications:
• Channel: Select the channel the PTZ camera
is connected to.
• Protocol: Sel
ect from Pelco-D or Pelco-P.
• Baud rate: Sel
ect the PTZ camera’s baud rate.
• Data Bit: Select fr
om 5~8 data bits.
• Stop Bit: Select fr
om 1 or 2 stop bits.
• Parity: Select from None, Odd, Even, Mark
or
Space.
• Cruise: Select
Enable to enable PTZ cruise.
• Address: Enter the PTZ camera’s address
Use the Copy To drop-down menu to copy the
PTZ settings to multiple channels.
4 Click
Apply
to save your settings.
Using the PTZ Menu (Local DVR)
To control the PTZ camera locally on your DVR:
1 Select the channel that the PTZ camera is connected to.
2 Press the PTZ butt
on once and release then press and hold. Enter the system password. The
PTZ menu opens.
PTZ button
Press and release then press and hold
3 Use the on-screen PTZ controls to control the camera.
Channel:
Select the channel the PTZ
camera connects to.
Click the + and - symbols to
adjust the camera Zoom,
Focus and Iris settings
Direction keys:
Click to pan and tilt
the camera
Speed Slider:
Increase or decrease the pan and tilt
speed
Camera Pre-set
controls