EasyManua.ls Logo

FLIR D3200 Series - Installing Hard Drives (D3332)

FLIR D3200 Series
177 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
158
Appendix E: Replacing the Hard Drive
4 Connect the power and data cables.
5 Replace the DVR cover.
Installing Hard Drives (D3332)
Make sure that the power cable has been disconnected before changing the
hard drive.
Steps to service the hard drives on D3332 depend if you are installing or removing hard
drives 1~4 or 5~8.
Step 1 of 3: Remove the DVR cover:
1 Remove the rear panel screws (2x).
NOTE: You do not need to remove the side panel screws.
2 Slide the top panel back about 1/2" and then lift it off of the D
VR.

Table of Contents

Related product manuals