152
Appendix C: Connecting Additional External Monitors
Main and Spot Video Outputs (D3316/D3332 Only)
On the D3316 and D3332, connect external monitors to either the Main or Spot port.
• The Spot port automatically shows channels in Sequence View. It can also be configured to
show 1 channel in full-scr
een or multiple channels in split-screen.
• The Main port can be used to connect an additional monitor for observation, or to use a BNC
monitor or TV (using a BNC t
o RCA adapter, not included) to control the DVR. You can press
0 on the remote control three times to switch the mouse and system interface between the
monitor connected to the VGA/HDMI port and the monitor connected to the Main port.
Configuring the Spot Monitor for Full-Screen or Split-Screen
By default, a monitor connected to the Spot port automatically shows channels in
Sequence View.
To configure the Spot monitor to show channels in split-screen:
1 Right-click to open the Menu Bar and click the Main Menu butt
on ( ).
2 Click Display and select the Output tab.
3 Under Video Output, select Spot-Out
to configure settings for the monitor connected to Spot.
4 Under View Setup, sel
ect Enable. This lets you select and arrange the channels you want to
show on the screen.
Select Spot-Out
Select Enable
5 Under View Mode, select Single to show 1 channel in full-screen, Quarter to show
4-channels in split-screen, or Ninth to show 9-channels in split-screen.
To Next Page
Loading...
Need help?
General
