81
Remote Viewing Interface
Restoring Default Settings
To restore the system’s system defaults:
1 Click the Remote Setting tab, and click Advanc
ed>Load Default.
2 Select the menus that you wish to restore to factory defaults.
3 Click Save to restore system defaults for the selected items.
Configuring Event Settings
The Event Settings tab allows you to configure how the system behaves when a system
event occurs (e.g. hard drive error, video loss). This is useful if you want your DVR to notify
you if there is a potential system problem.
To configure the system event settings:
1 Click the Remote Setting tab, and click Adv
anc
ed>Events.
2 Configure the following:
• Event Type: Configur
e the type of event that triggers the system to send an alert.
• Enable: Select Enabl
e to activate the system to notify you if an event occurs.
• Buzzer: Select
OFF to enable/disable the system buzzer or select the duration of the system
buzzer after an event occurs.
• Show Message: Select the checkbox to enable the system to display a warning message when
an e
vent occurs.
To Next Page
Loading...
