FLIR D3200 Series - Saving Your System Configuration to a USB Flash Drive; Loading a System Configuration from a USB Flash Drive

52
Using the Main Menu
To configure system warnings:
1 Click the Events
tab.
2 Configure the f
ollowing:
• Event Type: Select the event that triggers
the sys
tem to send out a notification or
alarm trigger. Choose from Disk No Space
(low hard drive space), Disk Error (hard
drive error), or Video Loss.
• Enabl
e: Select Enabl
e or Disable to
activate or deactivate the system from
sending out notifications.
• Alarm Out: Sel
ect the checkbo
x to enable
alarm out devices from triggering.
• Show Message: Select the checkbox for
the sys
tem to display an error message
when an event occurs.
• Send Email: Sel
ect the checkbo
x for the
system to send out email notifications
when a system error occurs. Note, email
notifications must be configured.
• Latch Time: Sel
ect the delay dur
ation in
the drop-down menu.
• Buzzer: Select the buzzer (sys
tem beep)
duration when the system detects a
system error.
3 Click Apply
to save your settings.
Saving Your System Configuration
to a USB Flash Drive
The DVR allows you to save your current
system configuration to a USB flash
drive (not included). This is useful if you
want to backup your current settings.
NOTE: This function only sav
es settings
created in system menus. It does not
save or backup any video.
To save your system configuration to a
USB flash drive (not included):
1 Insert a USB flash drive (not included) int
o
one of the USB ports.
2 Right-click to open the Menu Bar and click
Main Menu (
).
3 Click Advanc
ed and select the Maintain
tab.
4 Click Save Settings
. Wait for the system to
save your settings.
Click to save all system settings to a USB flash drive
Loading a System Configuration
from a USB Flash Drive
1 Insert a USB flash drive (not included) that
contains a saved configuration to a USB
port. See above for details on how to save
your DVR configuration.
2 Right-click to open the Menu Bar and click
Main Menu (
).
3 Click Advanc
ed and select the Maintain
tab.
4 Click Load Settings. The DVR will l
oad the
saved settings from the USB flash drive
and then restart.