031914 M2-9
5. Touch the “Delay Before Stop:”
button to set the “Runtime” duration
of the Chart.
6. Enter the “runtime” in the keypad
and touch the “OK” button.
7. Touch the “Channel Setup” button
to select the “Trigger Signal.”
8. Touch the “Signal Name” button.
9. Touch and highlight the signal on
the list that act as the “Trigger
Signal” and touch the “OK” button.
10. Touch the “Value” button to set the
“Trigger” Value.
11. Touch “0” or “1” and then touch
“OK.”
0 = When the Signal turns “Off.”
1 = When the Signal turns “On.”
12. Turn on the Slicer and run until the
“Event” occurs, then view the
“Event” Chart on Chart Recorder
screen.
To Next Page
Loading...