M4-12 031914
XS5 Infeed Housing Manifold: The Main
Profibus Cable travels from the optional
Powerloader
TM
or Takeaway Conveyor to
the XS5 Infeed Housing Manifold.
(Illustrations 23 and 24) If these options
are not used, the cable will travel from the
XS4 Scale Housing Manifold. There
should be a “Terminating Resistor”
installed on the XS5 Infeed Housing
Manifold. XS5 receives input signals from
the Loaf Gate positional proximities and
the 3 Loaf Length Sensors. XS5 also
send output signals to the directional
valves that operate the Loaf Gate, open
and close the Grippers and raise and
lower the Loaf Tray.
XS5 INFEED HOUSING MANIFOLD
ILLUSTRATION 23
ILLUSTRATION 24
AR15 DRIVER
CONTROL NODE
XS4 SCALE
HOUSING
MANIFOLD
XS5 INFEED
HOUSING
MANIFOLD
TERMINATING
RESISTOR
To Next Page
Loading...