Formax PowerMax 3000 - Page 8

SECTION 3 TOUCHSCREEN CONTROLS (con't)
“Production Data” Screen .......................3-5
“Service Screen” ............................3-6
SECTION 4 TOOLING
Tooling Care ..............................4-1
Knife Care ...............................4-1
Shear Bar Care.............................4-2
Gripper Assembly Care ........................4-3
SECTION 5 ASSEMBLY
Classifier Conveyors ..........................5-1
Transfer Conveyor ...........................5-2
Dynamic Scale Conveyors .......................5-4
Debris Conveyor ............................5-6
Gripper Drive ..............................5-8
Grippers ................................5-10
Lower Infeed Conveyors .......................5-11
Shear Bar ...............................5-12
Loaf Lift Tray .............................5-13
Slicing Conveyor ...........................5-14
Knife..................................5-16
Side Doors ..............................5-17
Power“On”..............................5-18
SECTION 6 OPERATION
Introduction ...............................6-1
Assemble the Machine .........................6-1
Power“On”...............................6-2
Login ..................................6-2
Move To “Ready” Position .......................6-3
Select Product Code ..........................6-4
Cycle Start ...............................6-4
Load Product ..............................6-5
Start Feed ...............................6-6
Stopping the Machine .........................6-6
Remove Product ............................6-6
Machine Adjustments .........................6-7
Adjustments Screen..........................6-17
Production Data Screen........................6-35
Weight Data Screen..........................6-36
TABLE OF CONTENTS
II