SECTION 7 PRODUCT CODE PARAMETERS
Introduction ...............................7-1
Selecting a Product Code .......................7-1
Editing a Product Code.........................7-2
Creating a Product Code ........................7-4
Keyboard Buttons ...........................7-5
Copy an Existing Product Code ....................7-6
Rename an Existing Product Code...................7-7
Delete a Product Code .........................7-8
Programming Product Code Parameters................7-9
SECTION 8 DISASSEMBLY AND CLEANUP
Raise Classifier Conveyors.......................8-1
Move to “Clean” Position ........................8-1
Power “Off” ...............................8-2
Remove Side Doors ..........................8-2
Remove the Knife ...........................8-3
Cover TouchScreen ..........................8-4
Disassemble Slicing conveyor .....................8-4
Disassemble Debris Conveyor .....................8-5
Remove Shear Bar ...........................8-7
Remove the Infeed Conveyors .....................8-7
Remove Grippers............................8-9
Remove the Lower Infeed Conveyor Belts ...............8-9
Disassemble the Gripper Drive Assembly ..............8-10
Disassemble the Loaf Lift Tray ....................8-12
Disassemble the Classifier Conveyors ................8-13
Disassemble the Dynamic Scale Conveyors .............8-14
Disassemble the Transfer Conveyor .................8-16
Cleaning Instructions .........................8-20
TABLE OF CONTENTS
III
To Next Page
Loading...