PORTION
Stack Correction/Slice Spacing/Shaved Product
Spacing: Depending on whether “Stack,” “Shingle” or
“Shaved” mode is selected in the “Portion Type”
parameter in the Product Code, determines which
adjustment will display on the list. (Illustration 50)
(“Stack” selected in the “Portion Type”):
If “Stack” is selected, the “Stack Correction” adjustment
displays is used to compensate for leaning stacks.
(Illustration 51) This parameter controls the distance that
the Slicing Conveyor will travel forward or backward,
while the stack is being sliced. Set this setting as a
positive or negative number depending on which way
the stack is leaning.
If the stack is leaning toward the rear of the machine, set
this as a “negative” distance. (Illustration 52)
If the stack is leaning toward the front of the machine,
set this adjustment as a “positive” number.
(Illustration 53)
6-20 031914
ILLUSTRATION 51
“STACK CORRECTION” ADJUSTMENT
ILLUSTRATION 50
PORTION TYPE SELECTION
ILLUSTRATION 53
FRONT LEANING
STACK
ILLUSTRATION 52
REAR LEANING
STACK
To Next Page
Loading...