220 U41840-J-Z125-7-76
I
If necessary, use the controls at the bottom of the table to navigate between
multiple pages of results. Select the number of rows to display in the Show
drop-down box.
7. In the Destination Location drop-down box, select the type of location you want to
move the cartridge to (Drive, Storage Slot, I/E Slot).
8. Select the destination location to move the cartridge to.
I
The destination section displays empty drives, storage slots, and I/E slots.
Offline drives are not displayed. A drive might be offline if it has not been
mapped to a host (see "Remote Host Access" on page 222).
9. Click Apply.
10. Return the partition to an online state (see "Changing Partition Mode" on page 211).
Media Unload
Use the Media Unload page to perform a bulk unload of virtual tape cartridges from drives
or I/E slots.
I
If you do not create and associate a host access group with a partition, the virtual
devices are not visible from the host, and drives cannot be destinations for move
operations (see "Remote Host Access" on page 222).
V
CAUTION!
If you unload a virtual tape cartridge from a drive while a backup to that drive is in
progress, the backup job will fail.
To access the Media Unload page, on the Media page, click the Unload tab (see
Figure 139).
To Next Page
Loading...
