224 U41840-J-Z125-7-76
Remote Host Mapping And Groups
The Remote Host Mapping And Groups section displays the following information for all
host access groups on the ETERNUS CS800:
● Group Name - The name of the group.
● Remote Host - The host (initiator) associated with the group.
● Target Port - The Fibre Channel port (target) associated with the group.
● Partition Name - The VTL partition associated with the group.
● Devices - The number of virtual media changers (VMCs) and virtual tape drives (VTDs)
associated with the group.
I
Click a column heading to sort the rows in the table by that column. Click the column
heading again to reverse the sort order.
Adding a Remote Host Access Group
Add a host access group to associate a VTL partition with a host (a Fibre Channel initiator
on the SAN) and a target (a Fibre Channel port on the ETERNUS CS800).
To add a host access group:
1. Click Add.
The Map Remote Hosts, Define Groups page displays (see Figure 141).
To Next Page
Loading...
