U41840-J-Z125-7-76 225
Figure 141: Map Hosts, Define Groups Page
2. Enter information about the host access group:
● Group Name - Enter a name for the group.
● Partition - Select the partition to associate with the group.
● Remote Host - Select the host (initiator) to associate with the group.
I
You must configure a host before it is available in the Host drop-down box
(see "Remote Hosts" on page 228).
● Target - Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical representation of the Fibre
Channel and Ethernet ports as they appear on the rear of the system. A dark border
displays around the currently selected target.
I
If a target is directly connected to the system, only the directly connected
ports are displayed. Otherwise, all ports are displayed.
3. (Optional) Select the Use CCL check box to use the Command and Control LUN.
To Next Page
Loading...
