Fujitsu ETERNUS CS800 S5 - Page 317

Configuration System
U41840-J-Z125-7-76 303
Changing Web Passwords
Use the Web passwords when logging onto the remote management console as an admin-
istrator or monitor (see "Accessing Remote Management" on page 125).
To change the Web passwords:
1. Under Web Administrator Password or under Web Monitor Password, enter the
following information:
● Old Password - Enter the old password.
● New Password - Enter the new password.
● Confirm New Password - Enter the new password again to confirm it.
I
The default Web Administrator password is spcc. The default Web Monitor
password is password.
I
Passwords are limited to 15 characters. All alphanumeric characters are
allowed, as well as underscores ( _ ) and hyphens ( - ).
2. Click Apply.
Enabling CLI Accounts
The CLI accounts provide access to the ETERNUS CS800 command line interface as an
administrator or monitor.
I
For more information about using the CLI, see the ETERNUS CS800 S5 Command Line
Interface (CLI) Guide.
To enable or disable the CLI accounts:
1. Under CLI Administrator Login Settings or under CLI Monitor Login Settings, do
one of the following steps:
● Select the Enable CLI Login check box to enable the CLI account.
● Clear the Enable CLI Login check box to disable the CLI account.
2. Click Apply.