436 U41840-J-Z125-7-76
Figure 264: Performance Page
To perform network analysis:
1. In the Target IP Address box, enter the IP address of the system to perform network
analysis with.
The target system must have NetServer enabled (see "Settings" on page 436).
2. Click Start.
The throughput result is displayed under Result From Last Run in MB/s.
I
It takes approximately 5 seconds to refresh the results.
Settings
The Settings page allows you to enable or disable NetServer on the ETERNUS CS800.
NetServer must be enabled on the target system to perform network analysis with the
system (see "Performance" on page 435).
To access the Settings page, on the Network Analyzer page, click the Settings tab (see
Figure 265).
To Next Page
Loading...
