Removal and Replacement Procedures for CRUs ETERNUS CS800 S4/S5 Hardware
U41840-J-Z125-7-76 511
Figure 298: Removing a 2.5-inch HDD
Installing a 2.5-inch HDD
1. Unlock the HDD module as described above.
2. Insert the HDD module into a drive bay and carefully push back as far as it will go (1).
3. Close the locking lever to lock the hard disk drive in place (2).
4. If the status of the HDD remains "unknown" after rebuild has finished, contact Fujitsu
Customer Support (see "Support and Help" on page 18).
To Next Page
Loading...
