157
Web overview
The device provides web-based configuration interfaces for visual device management and
maintenance.
Figure 162 Web-based network management operating environment
Logging in to the web interface
You can use the following default settings to log in to the web interface:
• Username—admin
• Password—password
To log in to the web interface of the device from a PC:
1. Connect the Ethernet port of the device to the PC by using a crossover Ethernet cable.
By default, all ports belong to VLAN 1.
2. Configure an IP address for the PC and make sure that the PC and device can reach each other.
For example, assign the PC an IP address (for example, 192.168.0.2) within the network segment
192.168.0.0/24 (except for 192.168.0.50).
3. Open the browser and input the login information:
a. Type the IP address http://192.168.0.50 in the address bar, and press Enter.
The login page of the web interface (see Figure 163) appears.
b. Enter the username admin and password pas
sword, and the verification code, select the
language (English and Chinese are supported at present), and click Login.
Figure 163 Login page of the web interface
To Next Page
Loading...
Need help?
General
