H3C WA Series

291
Figure 288 Repeater mode
Configuring the workgroup bridge
Enabling the client mode
1. Select Wireless Service > Client Mode from the navigation tree.
2. Click Connect Setup.
Figure 289 Enable the client mode
3. Select the radio unit for which the client mode is to be enabled.
4. Click Enable.
NOTE:
• Support for radio modes depends on your device model.
• You cannot enable an access service or WDS service on a radio interface with the client mode enabled.
• To modify the radio mode, select Radio > Radio from the navigation tree, click the icon
corresponding to the target radio, and change the radio mode in Radio Mode. You can modify the
radio mode only when the client mode is disabled.
• If the 802.11(2.4GHz)/802.11(5GHz) client mode is used, the client can scan
802.11(2.4GHz)/802.11(5GHz) wireless services.