68
Table 34 Configuration items
Item Descri
tion
Create/Remove
Set the operation type:
• Create: Configure or modify the super password.
• Remove: Remove the current super password.
Password
Set the password for a user to switch to the management level.
Confirm Password
Enter the same password again. Otherwise, the system prompts that the two passwords
enter are not consistent when you apply the configuration.
Switching the user access level to the management
level
This function is provided for a user to switch the current user level to the management level. Note the
following:
• Before switching, make sure that the super password is already configured. A user cannot switch to
the management level without a super password.
• The access level switchover of a user is valid for the current login only. The access level configured
for the user is not changed. When the user re-logs in to the web interface, the access level of the
user is still the original level.
To switch the user access level to the management level:
1. Select Device > Users from the navigation tree.
2. Click the Switch To Management tab.
The access level switching page appears.
Figure 60 Switch to the management level.
3. Enter the super password.
4. Click Login.
To Next Page
Loading...
Need help?
General
