H3C WA Series

393
Figure 416 Wireless QoS
2. Select the option in front of the radio unit to be configured.
3. Click Enable.
By default, WMM is enabled.
NOTE:
The WMM protocol is the foundation of the 802.11n protocol. When the radio works in 802.11n (5 GHz)
or 802.11n (2.4 GHz) radio mode, you must enable WMM. Otherwise, the associated 802.11n clients
may fail to communicate properly.
Setting the SVP service
NOTE:
SVP mapping is applicable to only non-WMM client access.
1. Select QoS > Wireless QoS from the navigation tree.
By default, the QoS Service tab is displayed.
Figure 417 Wireless QoS
2. Click the icon for the desired radio to enter the page for mapping SVP service to an access
category.
Figure 418 Mapping SVP service to an access category