H3C WA Series User Manual

286
Configuring a neighbor MAC address
NOTE:
If no neighbor MAC address is configured for an AP, the AP can establish a WDS link with any other AP;
if a neighbor MAC address is configured for an AP, the AP can establish a WDS link with only the
specified peer AP.
1. Select Wireless Service > WDS from the navigation tree.
2. Select the radio mode to be configured, and click the icon to enter the page for configuring a
neighbor MAC address.
Figure 284 Configure a neighbor MAC address
3. Enter the MAC address in the Neighbor MAC Address field, and click Add.
4. Click Apply.
Configuring advanced WDS settings
1. Select Wireless Service > WDS from the navigation tree.
2. Click the WDS Setup tab.
3. Click the icon corresponding to the target radio mode to be configured.
The page for configuring advanced WDS appears.

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English