343
Figure 375 Configure the same channel
3. Enable 802.11n (2.4GHz) radio (By default, 802.11n (2.4GHz) is enabled.).
Select Radio > Radio from the navigation tree to enter the Radio page. Make sure 802.11n
(2.4GHz) is enabled.
4. Enable WDS:
a. Select Wireless Service > WDS from the navigation tree.
b. Select the box corresponding to 802.11n (2.4GHz).
c. Click Enable.
Figure 376 WDS setup page
5. Configure the access service
NOTE:
For how to configure the access service on the repeater, see "Wireless service configuration example."
You
can strictly follow the steps in Wireless service configuration example to
confi
ure the access service
on the repeater.
To Next Page
Loading...
