Honeywell Fusion4 MSC-L - Page 458

Operation - Calibration
Fusion4 MSC-L Part No.: 4418309_Rev09
5 - 270 Installation & Operation Manual
Honeywell
11. Select <OK> on the IR controller or LAD to accept the new meter
factor or <ESC> to reject the meter factor.
If <OK> is selected, then a message appears informing if you want to
repeat the calibration runs.
12. Following options can be performed.
 Select <OK> on the IR controller or LAD to repeat calibration on the
same flow rate.
NOTE: Maximum of 5 calibrations can be performed for a
single flow rate.

Select <Cancel> to terminate the operation.