103
network (OSPF area view)
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
View
OSPF area view
Default level
2: System level
Parameters
ip-address: IP address of a network.
wildcard-mask: Wildcard mask of the IP address. For example, the wildcard mask of mask 255.0.0.0 is
0.255.255.255.
Description
Use network to enable OSPF on the interface attached to the specified network in the area.
Use undo network to disable OSPF for the interface attached to the specified network in the area.
By default, an interface neither belongs to any area nor runs OSPF.
You can configure one or multiple interfaces in an area to run OSPF. The interface’s primary IP address
must fall into the specified network segment to make the interface run OSPF. If only the interface’s
secondary IP address falls into the network segment, the interface cannot run OSPF.
Related commands: ospf.
Examples
# Specify the interface whose primary IP address falls into 131.108.20.0/24 to run OSPF in Area 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] area 2
[Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255
nssa
Syntax
nssa [ default-route-advertise | no-import-route | no-summary | translate-always |
translator-stability-interval value ] *
undo nssa
View
OSPF area view
Default level
2: System level
To Next Page
Loading...
Need help?
General