Cost Cost to destination
Type Route type: intra-area, transit, stub, inter-area, type1 external, type2 external.
NextHop Next hop address
AdvRouter Advertising router
Area Area ID
Total Nets Total networks
Intra Area Total intra-area routes
Inter Area Total inter-area routes
ASE Total ASE routes
NSSA Total NSSA routes
display ospf vlink
Syntax
display ospf [ process-id ] vlink [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
process-id: OSPF process ID, in the range of 1 to 65535.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display ospf vlink to display OSPF virtual link information.
If no OSPF process is specified, the OSPF virtual link information of all OSPF processes is displayed.
Examples
# Display OSPF virtual link information.
<Sysname> display ospf vlink
OSPF Process 1 with Router ID 3.3.3.3
Virtual Links
Virtual-link Neighbor-ID -> 2.2.2.2, Neighbor-State: Full
Interface: 10.1.2.1 (Vlan-interface20)
To Next Page
Loading...
Need help?
General