352
ip extcommunity-list
Syntax
ip extcommunity-list ext-comm-list-number { deny | permit } { rt route-target }&<1-16>
undo ip extcommunity-list ext-comm-list-number
View
System view
Default level
2: System level
Parameters
ext-comm-list-number: Extended community list number, in the range of 1 to 199.
deny: Specifies the match mode for the extended community list as deny.
permit: Specifies the match mode for the extended community list as permit.
rt route-target: Specifies the RT extended community attribute, a string of 3 to 21 characters.
A route-target has three forms:
• A 16-bit AS number: a 32-bit self-defined number, for example, 101:3;
• A 32-bit IP address: a 16-bit self-defined number, for example, 192.168.122.15:1.
• A 32-bit AS number: 16-bit self-defined number, for example, 70000:3. The AS number should be
no less than 65536.
&<1-16>: Indicates the argument before it can be entered up to 16 times.
Description
Use ip extcommunity-list to define an extended community list entry.
Use undo ip extcommunity-list to remove an extended community list.
No extended community list is defined by default.
Examples
# Define extended community list 1 to permit routing information with RT 200:200.
<Sysname> system-view
[Sysname] ip extcommunity-list 1 permit rt 200:200
route-policy
Syntax
route-policy route-policy-name { deny | permit } node node-number
undo route-policy route-policy-name [ deny | permit ] [ node node-number ]
View
System view
Default level
2: System level
To Next Page
Loading...
