HP 6125G - Peer Description (BGP;BGP-VPN Instance View); Peer Dscp (BGP;BGP-VPN Instance View)

179
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test default-route-advertise
peer description (BGP/BGP-VPN instance view)
Syntax
peer { group-name | ip-address } description description-text
undo peer { group-name | ip-address } description
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
description-text: Description information for the peer/peer group, a string of 1 to 79 characters.
Description
Use peer description to configure the description information for a peer/peer group.
Use undo peer description to remove the description information of a peer/peer group.
By default, no description information is configured for a peer/peer group.
Create a peer/peer group before configuring a description for it.
Related commands: display bgp peer.
Examples
# In BGP view, configure the description information of the peer group test as ISP1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test description ISP1
# In BGP-VPN instance view, configure the description information of the peer group test as ISP1. (The
VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test description ISP1
peer dscp (BGP/BGP-VPN instance view)
Syntax
peer { group-name | ip-address } dscp dscp-value
undo peer { group-name | ip-address } dscp