313
peer ebgp-max-hop (IPv6 address family view)
Syntax
peer { ipv6-group-name | ipv6-address } ebgp-max-hop [ hop-count ]
undo peer { ipv6-group-name | ipv6-address } ebgp-max-hop
View
IPv6 address family view
Default level
2: System level
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
hop-count: Maximum hop count, in the range of 1 to 255. By default, the value is 64.
Description
Use peer ebgp-max-hop to allow establishing the EBGP connection to a peer/peer group indirectly
connected.
Use undo peer ebgp-max-hop to remove the configuration.
By default, this feature is disabled.
You can use the argument hop-count to specify the maximum router hops of the EBGP connection.
Examples
# Allow establishing the EBGP connection with the peer group test on an indirectly connected network.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test ebgp-max-hop
peer enable (IPv6 address family view)
Syntax
peer { ipv4-group-name | ipv4-address | ipv6-address } enable
undo peer { ipv4-group-name | ipv4-address | ipv6-address } enable
View
IPv6 address family view
Default level
2: System level
Parameters
ipv4-group-name: Name of an IPv4 peer group, a string of 1 to 47 characters. The IPv4 peer group
should be created beforehand.
ipv4-address: IPv4 address of a peer.
To Next Page
Loading...
