48
rip input
Syntax
rip input
undo rip input
View
Interface view
Default level
2: System level
Parameters
None
Description
Use rip input to enable the interface to receive RIP messages.
Use undo rip input to disable the interface from receiving RIP messages.
By default, an interface is enabled to receive RIP messages.
Examples
# Disable VLAN-interface 10 from receiving RIP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] undo rip input
rip metricin
Syntax
rip metricin [ route-policy route-policy-name ] value
undo rip metricin
View
Interface view
Default level
2: System level
Parameters
route-policy route-policy-name: Specifies the name of a routing policy used to add an additional metric
for the routes matching it. The name is a string of 1 to 63 case-sensitive characters.
value: Additional metric added to received routes, in the range of 0 to 16.
Description
Use rip metricin to configure the interface to add a metric to the routes it receives.
Use undo rip metricin to restore the default.
By default, the additional metric of a received route is 0.
To Next Page
Loading...
