121
nbrstatechange: Neighbor state change information.
originatelsa: Information about LSAs originated locally.
vifauthfail: Virtual interface authentication failure information.
vifcfgerror: Virtual interface configuration error information.
virifauthfail: Virtual interface authentication failure information.
virifrxbadpkt: Information about error packets received by virtual interfaces.
virifstatechange: Virtual interface state change information.
viriftxretransmit: Virtual interface packet retransmission information.
virnbrstatechange: Virtual interface neighbor state change information.
Description
Use snmp-agent trap enable ospf to enable the sending of SNMP traps for a specified OSPF process. If
no process is specified, the feature is enabled for all processes.
Use undo snmp-agent trap enable ospf to disable the feature.
By default, this feature is enabled.
See Network Management and Monitoring Command Reference for related information.
Examples
# Enable the sending of SNMP traps for OSPF process 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable ospf 1
spf-schedule-interval
Syntax
spf-schedule-interval maximum-interval [ minimum-interval [ incremental-interval ] ]
undo spf-schedule-interval
View
OSPF view
Default level
2: System level
Parameters
maximum-interval: Maximum OSPF route calculation interval in seconds, in the range of 1 to 60.
minimum-interval: Minimum OSPF route calculation interval in milliseconds, in the range of 10 to 60000,
which defaults to 0.
incremental-interval: Incremental value in milliseconds, in the range of 10 to 60000, which defaults to
5000.
Description
Use spf-schedule-interval to set the OSPF SPF calculation interval.
Use undo spf-schedule-interval to restore the default.
The interval defaults to 5 seconds.
To Next Page
Loading...
