304
peer advertise-ext-community (IPv6 address family view)
Syntax
peer { group-name | ipv4-address | ipv6-address } advertise-ext-community
undo peer { group-name | ipv4-address | ipv6-address } advertise-ext-community
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
Description
Use peer advertise-ext-community to advertise the extended community attribute to a peer/peer group.
Use undo peer advertise-ext-community to remove the configuration.
By default, no extended community attribute is advertised to a peer/peer group.
Examples
# Advertise the extended community attribute to the peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 advertise-ext-community
peer allow-as-loop (IPv6 address family view)
Syntax
peer { group-name | ipv4-address | ipv6-address } allow-as-loop [ number ]
undo peer { group-name | ipv4-address | ipv6-address } allow-as-loop
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
number: Specifies the number of times for which the local AS number can appear in routes from the
peer/peer group, in the range of 1 to 10. The default number is 1.
To Next Page
Loading...
