HP 6125G - Reflect Between-Clients (BGP View;Bgp-VPN Instance View)

197
Examples
# In BGP view, configure preferences for EBGP, IBGP and local routes as 20, 20, and 200.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] preference 20 20 200
# In BGP-VPN instance view, configure preferences for EBGP, IBGP and local routes as 20, 20, and 200.
(The VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] preference 20 20 200
reflect between-clients (BGP view/BGP-VPN instance view)
Syntax
reflect between-clients
undo reflect between-clients
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
None
Description
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
By default, route reflection between clients is enabled.
After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route
reflector are fully meshed, you need disable route reflection between clients to reduce routing costs.
Related commands: reflector cluster-id and peer reflect-client.
Examples
# Disable route reflection between clients.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] undo reflect between-clients
# In BGP-VPN instance view, disable route reflection between clients. (vpn1 must have been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] undo reflect between-clients