191
# In BGP-VPN instance view, carry no private AS number in BGP updates sent to the peer group test. (The
VPN has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test public-as-only
peer reflect-client (BGP/BGP-VPN instance view)
Syntax
peer { group-name | ip-address } reflect-client
undo peer { group-name | ip-address } reflect-client
View
BGP view, BGP-VPN instance view
Default level
2: System level
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
Description
Use peer reflect-client to configure the router as a route reflector and specify a peer/peer group as a
client.
Use undo peer reflect-client to remove the configuration.
By default, neither the route reflector nor the client is configured.
Related commands: reflect between-clients and reflect cluster-id.
Examples
# In BGP view, configure the local device as a route reflector and specify the IBGP peer group test as a
client.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test reflect-client
# In BGP-VPN instance view, configure the local device as a route reflector and specify the IBGP peer
group test as a client. (vpn1 must have been created.)
<Sysname> system-view
[Sysname] bgp 109
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] peer test reflect-client
peer route-limit (BGP/BGP-VPN instance view)
Syntax
peer { group-name | ip-address } route-limit prefix-number [ { alert-only | reconnect reconnect-time } |
percentage-value ] *
To Next Page
Loading...
Need help?
General