145
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display bgp peer received ip-prefix to display the prefix information in the ORF packet from the
specified BGP peer.
Examples
# Display the prefix information in the ORF packet from the BGP peer 10.110.25.20.
<Sysname> display bgp peer 10.110.25.20 received ip-prefix
ORF ip-prefix entries: 2
ge: greater-equal le: less-equal
index rule prefix ge le
10 permit 111.111.111.0/24 26 32
20 deny 2.1.1.0/24 26 32
Table 34 Command output
Field Description
ORF ip-prefix entries Number of ORF prefix entries
index Index of a prefix entry
rule Matching rule of the prefix
prefix Prefix information
ge
greater-equal, indicating the mask length must be
greater than or equal to the specific value.
le
less-equal, indicating the mask length must be less
than or equal to the specific value.
display bgp routing-table
Syntax
display bgp routing-table [ ip-address [ { mask | mask-length } [ longer-prefixes ] ] ] [ | { begin | exclude
| include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
ip-address: Destination IP address.
mask: Network mask, in dotted decimal notation.
mask-length: Mask length, in the range of 0 to 32.
longer-prefixes: Displays the routing entries selected through the following steps:
To Next Page
Loading...
