123
[Sysname-ospf-100-area-0.0.0.1] stub
stub-router
Syntax
stub-router
undo stub-router
View
OSPF view
Default level
2: System level
Parameters
None
Description
Use stub-router to configure the router as a stub router.
Use undo stub-router to restore the default.
By default, no router is configured as a stub router.
The router LSAs from the stub router may contain different link type values. A value of 3 means a link to
the stub network, so the cost of the link remains unchanged. A value of 1, 2 or 4 means a point-to-point
link, a link to a transit network or a virtual link; in such cases, a maximum cost value of 65535 is used.
If other neighbors find the links to the stub router have such big costs, they will not send packets to the stub
router as long as a route with a smaller cost exists.
Examples
# Configure the router as a stub router.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] stub-router
transmit-pacing
Syntax
transmit-pacing interval interval count count
undo transmit-pacing
View
OSPF view
Default level
2: System level
Parameters
interval: Interval at which an interface sends LSU packets, in milliseconds. Its value is in the range of 10
to 1000. If the router has a number of OSPF interfaces, HP recommends increasing this interval to reduce
the total numbers of LSU packets sent by the router every second.
To Next Page
Loading...
Need help?
General