314
ipv6-address: IPv6 address of a peer.
Description
Use peer enable to enable an IPv4 peer or peer group.
Use undo peer enable to disable an IPv4 peer or peer group.
By default, no IPv4 peer or peer group is enabled.
If an IPv4 peer or peer group is disabled, the router will not exchange routing information with it.
Examples
# E n a b l e p e e r 1.1.1.1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1.1.1.1 enable
# Enable peer 1::1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1::1 group group1
[Sysname-bgp-af-ipv6] peer 1::1 enable
peer fake-as (IPv6 address family view)
Syntax
peer { ipv6-group-name | ipv6-address } fake-as as-number
undo peer { ipv6-group-name | ipv6-address } fake-as
View
IPv6 address family view
Default level
2: System level
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
as-number: Local AS number, in the range of 1 to 4294967295.
Description
Use peer fake-as to configure a fake local AS number for a peer or peer group.
Use undo peer fake-as to remove the configuration.
By default, no fake local AS number is configured for a peer or peer group.
Examples
# Configure a fake AS number of 200 for the peer group test.
<Sysname> system-view
[Sysname] bgp 100
To Next Page
Loading...
