29
Description
Use default cost to configure the default metric for redistributed routes.
Use undo default cost to restore the default.
By default, the default metric of redistributed routes is 0.
When you use the import-route command to redistribute routes from other protocols without specifying
a metric, the metric specified by the default cost command applies.
Related command: import-route.
Examples
# Configure the default metric for redistributed routes as 3.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default cost 3
default-route
Syntax
default-route { only | originate } [ cost cost ]
undo default-route
View
RIP view
Default level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises both a default route and other routes.
cost: Cost of the default route, in the range of 1 to 15. The default is 1.
Description
Use default-route to configure all the interfaces under the RIP process to advertise a default route with the
specified metric to RIP neighbors.
Use undo default-route to disable all the interfaces under the RIP process from sending a default route.
By default, no default route is sent to RIP neighbors.
The RIP router with this feature configured will not receive any default routes from RIP neighbors.
Related commands: rip default-route.
Examples
# Configure all the interfaces under RIP process 100 to send only a default route with a metric of 2 to RIP
neighbors.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default-route only cost 2
To Next Page
Loading...
Need help?
General