50
• Routes matching the policy is added with the metric specified in the apply cost command
configured in the policy. Routes not matching it is added with the metric specified in the rip
metricout command. The rip metricout command does not support the + or – keyword—used to
add or reduce a metric—specified in the apply cost command. For more information about the
apply cost command, see "Routing policy configuration commands."
• If the apply cost command is not configured in the policy, all the advertised routes is added with the
metric specified in the rip metricout command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 for the outgoing route 1.0.0.0/8 and to add a
metric of 2 for other outgoing routes.
<Sysname> system-view
[Sysname] ip ip-prefix 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
[Sysname-route-policy] if-match ip-prefix 123
[Sysname-route-policy] apply cost 6
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip metricout route-policy abc 2
rip mib-binding
Syntax
rip mib-binding process-id
undo rip mib-binding
View
System view
Default level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use rip mib-binding to bind MIB operations with a specified RIP process, so that the RIP process can
receive SNMP requests.
Use undo rip mib-binding to restore the default.
By default, MIB operations are bound to RIP process 1. RIP process 1 is enabled to receive SNMP
requests.
Examples
# Enable RIP process 100 to receive SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding
To Next Page
Loading...
Need help?
General