HP 6125G - If-Match Acl; If-Match Ip

355
Field Description
Permitted Number of routes satisfying the match criterion
Denied Number of routes not satisfying the match criterion
index Index of the IPv4 prefix list
permit Match mode: permit or deny
1.0.0.0/11 IP address and mask
ge greater-equal, the lower limit
le less-equal, the higher limit
if-match acl
Syntax
if-match acl acl-number
undo if-match acl
View
Routing policy view
Default level
2: System level
Parameters
acl-number: ACL number from 2000 to 3999.
Description
Use if-match acl to configure an ACL match criterion.
Use undo if-match acl to remove the match criterion.
No ACL match criterion is configured by default.
Examples
# Configure node 10 of routing policy policy1 to permit routes matching ACL 2000.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match acl 2000
if-match ip
Syntax
if-match ip { next-hop | route-source } { acl acl-number | ip-prefix ip-prefix-name }
undo if-match ip { next-hop | route-source } [ acl | ip-prefix ]
View
Routing policy view
Default level
2: System level