57
Examples
# Disable the source IP address validation on incoming RIP routing updates.
<Sysname> system-view
[Sysname-rip] rip 100
[Sysname-rip-100] undo validate-source-address
version
Syntax
version { 1 | 2 }
undo version
View
RIP view
Default level
2: System level
Parameters
1: Specifies the RIP version as RIPv1.
2: Specifies the RIP version as RIPv2. RIPv2 messages are multicast.
Description
Use version to specify a global RIP version.
Use undo version to remove the configured global RIP version.
By default, if an interface has a RIP version specified, the RIP version takes effect; if it has no RIP version
specified, it can send RIPv1 broadcasts, and receive RIPv1 broadcasts and unicasts, and RIPv2
broadcasts, multicasts, and unicasts.
If an interface has an RIP version specified, the RIP version takes precedence over the global RIP version.
If no RIP version is specified for the interface and the global version is RIPv1, the interface inherits RIPv1,
and it can send RIPv1 broadcasts, and receive RIPv1 broadcasts and unicasts.
If no RIP version is specified for the interface and the global version is RIPv2, the interface operates in the
RIPv2 multicast mode, and it can send RIPv2 multicasts, and receive RIPv2 broadcasts, multicasts, and
unicasts.
Examples
# Specify RIPv2 as the global RIP version.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] version 2
To Next Page
Loading...
Need help?
General