265
View
Interface view
Default level
2: System level
Parameters
seconds: Poll interval in seconds, in the range of 1 to 65535.
instance-id: Interface instance ID, in the range of 0 to 255. The default is 0.
Description
Use ospfv3 timer poll to set the poll interval on an NBMA interface.
Use undo ospfv3 timer poll to restore the default value.
By default, the poll interval is 120 seconds.
Examples
# Set the poll timer interval on the current interface to 130 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospf timer poll 130
ospfv3 trans-delay
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ seconds ] [ instance instance-id ]
View
Interface view
Default level
2: System level
Parameters
seconds: Transmission delay in seconds, ranging from 1 to 3600.
instance-id: Instance ID of an interface, in the range of 0 to 255, with the default as 0.
Description
Use ospfv3 trans-delay to configure the transmission delay for an interface with an instance ID.
Use undo ospfv3 trans-delay to restore the default.
The transmission delay defaults to 1s.
As LSAs are aged in the LSDB (incremented by 1 every second) but not aged on transmission, it is
necessary to add a delay time to the age time before sending a LSA. This configuration is important for
low-speed networks.
Examples
# Configure the transmission delay as 3 seconds for an interface in instance 1.
<Sysname> system-view
To Next Page
Loading...
Need help?
General