HP 6125G - Ripng Configuration Commands; Checkzero; Default Cost (Ripng View)

208
RIPng configuration commands
The term "router" in this chapter refers to both routers and Layer 3 switches.
checkzero
Syntax
checkzero
undo checkzero
View
RIPng view
Default level
2: System level
Parameters
None
Description
Use checkzero to enable the zero field check on RIPng packets.
Use undo checkzero to disable the zero field check.
The zero field check is enabled by default.
Some fields in RIPng packet headers must be zero. These fields are called "zero fields". You can enable
the zero field check on RIPng packet headers. If any such field contains a non-zero value, the RIPng
packet will be discarded.
Examples
# Disable the zero field check on RIPng packet headers of RIPng 100.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] undo checkzero
default cost (RIPng view)
Syntax
default cost cost
undo default cost
View
RIPng view
Default level
2: System level