318
View
IPv6 address family view
Default level
2: System level
Parameters
group-name: Name of an IPv4 or IPv6 peer group, a string of 1 to 47 characters.
ipv4-address: IPv4 address of a peer.
ipv6-address: IPv6 address of a peer.
Description
Use peer keep-all-routes to save the original routing information from a peer or peer group, including
even routes that failed to pass the inbound policy.
Use undo peer keep-all-routes to disable this function.
By default, the function is not enabled.
Examples
# Save routing information from peer 1:2::3:4.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] peer 1:2::3:4 keep-all-routes
peer log-change (IPv6 address family view)
Syntax
peer { ipv6-group-name | ipv6-address } log-change
undo peer { ipv6-group-name | ipv6-address } log-change
View
IPv6 address family view
Default level
2: System level
Parameters
ipv6-group-name: Name of a peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
Description
Use peer log-change to enable the logging of session state and event information of a specified peer or
peer group.
Use undo peer log-change to remove the configuration.
The logging is enabled by default.
Examples
# Enable the logging of session state and event information of peer 1:2::3:4.
To Next Page
Loading...
