383
undo ipv4-family vpn-instance vpn-instance-name
View
BGP view
Default level
2: System level
Parameters
vpn-instance vpn-instance-name: Associates a VPN instance with an IPv4 address family and enters BGP
VPN instance view. The vpn-instance-name argument specifies the VPN instance name, a case-sensitive
string of 1 to 31 characters.
Description
Use ipv4-family vpn-instance to enter BGP-VPN instance view.
Use undo ipv4-family vpn-instance to remove all the configurations performed in the view.
Before entering BGP VPN instance view, make sure the corresponding VPN instance is created.
Examples
# Enter BGP-VPN instance view.
<Sysname> system-view
[Sysname] bgp 100
[Sysname] ipv4-family vpn-instance vpn1
[Sysname-bgp-vpn1]
peer allow-as-loop
Syntax
peer { group-name | ip-address } allow-as-loop [ number ]
undo peer { group-name | ip-address } allow-as-loop
View
BGP-VPN instance view
Default level
2: System level
Parameters
group-name: Name of the peer group, a string of 1 to 47 characters.
ip-address: IP address of the peer.
number: Maximum number that the local AS number can appear repeatedly in the AS-PATH attribute. It
ranges from 1 to 10 and defaults to 1.
Description
Use peer allow-as-loop to allow the local AS number to appear in the AS-PATH attribute of a received
route and to set the allowed maximum number of repetitions.
Use undo peer allow-as-loop to remove the configuration.
To Next Page
Loading...
Need help?
General